Home » Mechanical Engineering » DESIGN AND FABRICATION OF A METAL BOOKSHELF

DESIGN AND FABRICATION OF A METAL BOOKSHELF

Sold By: Joe Project Store | Item Type: Project Material | Report this?  |  Attributes: 65 pages | 1-5 chapters | Amount: ₦5,000 | Marked useful: 4,879 times

Delivery: Within 24 hours
ABSTRACT
Knowledge could only be obtained successfully by the use of book for research but unfortunately because of hard times, books have become very expensive.  This is called for presentation of books already purchased whether in the library or on the household so that it can be used by the future generation.  There could only be done by stacking books systematically on a book rack where by it can be file from rats and other insects that could destroy books.
Our aim contribution to this development is the design and manufacture of a book rack that will be economically cheap and at the same time meet up its demands.
Book racks could be made with metals or wood.  Again they could be attacked to the wall or they could be made standby on the floor.  Our book rack will be of metal and made to stand on the floor.
TABLE OF CONTENTS
Title page
Letter of approval
Release 
Signature
Approval
Dedication
Acknowledge
Abstract
CHAPTER ONE
1.1 Introduction
1.2 Description Of The Bookshelf
CHAPTER TWO
2.1 Mode Of Operation
2.2 Material Selection
CHAPTER THREE
3.1 Design
3.2 Design Analysis
3.3 Capacity Of The Bookshelf
3.4 Design Experiments
3.5 Construction
3.6 Sequence Of Operation
CHAPTER FOUR
4.1 Cost Of Analysis
CHAPTER FIVE
5.1 Conclusion
5.2 Recommendation
5.3 Reference

This material content is developed to serve as a GUIDE for students to conduct academic research



Delivery: Within 24 hours

Advertise Here

For advertisement, call 08168958821

Not what you were looking for? Perform a search

What's your project topic?


Comment on Facebook: