CONSTRUCTION OF A GSM BASED HOME AUTOMATION USING AVR
Sold By: Joe Project Store | Item Type: Project Material | Report this? | Attributes: 65 pages | 1-5 chapters | Amount: ₦5,000 | 5 orders. | Marked useful: 5,352 times
INSTANT PROJECT MATERIAL DOWNLOADABSTRACT
With advancement of technology things are becoming simpler and easier for us. Automatic systems are being preferred over manual system. The purpose of this project is to design and construct A GSM based home automation using AVR. Using GSM networks, in this project a home power control system has been proposed that will act as an embedded system which can monitor and control appliances and other devices locally using built-in input and output peripherals. The system has a delay of 2 minutes after the first call to initiate the next command. This project is made up of four vital units. These units are as follows: GSM module unit, peripheral interface control (PIC) unit, driver unit and a power monitoring and control unit. The GSM module is a GSM transceiver which gives the system access to the GSM service provider. The peripheral interface control (PIC) is programmed to carry out the OFF/ RESET operation according to the GSM commands while the driver and control unit consist of capacitors, resistors, diodes, regulators and electromagnetic relay is to effect power switching. The major component that performed the power control of 220v main supply and the automatic voltage regulation (AVR) is the automated electromagnetic relay. The project was realized.
TABLE OF CONTENT
CHAPTER ONE: INTRODUCTION
1.1
Introduction To The Project-
1.2
Background Of Study-
-
1.3
Problem Statement-
-
-
1.4
Aims And Objectives-
-
1.5
Scopes And Purpose Of System Specification- -
1.6
Limitations-
CHAPTER TWO: LITERATURE REVIEW
2.1
Review of Related Works-
-
-
2.2
Home Automation System- -
-
-
2.3
Brief History of Tone Recognition Device--
2.4
History of Home Automation-
-
-
2.4.1 The Mechanical Evolution-
-
2.4.2 The Electrical Evolution- -
-
2.4.3 The Information Revolution-
-
2.5
Smart Home Today-
-
-
-
2.6
Aspects of Automation Speech Recognition (ASR) Device- -
CHAPTER THREE: SYSTEM ANALYSIS AND METHODOLOGY
3.1
Hardware Subsystem-
-
3.2
System Analysis-
-
-
3.3
Regulation Unit-
-
-
3.4
The Power Supply -
-
-
3.5
The Microcontroller- -
-
3.6
The System Flow Chart-
-
CHAPTER FOUR: CONSTRUCTION AND COMPONENT LIST
4.1
Construction- -
-
-
-
4.2
Constructional Methods-
-
This material content is developed to serve as a GUIDE for students to conduct academic research
DOWNLOAD THIS PROJECT MATERIAL NOW!
Advertise Here
Not what you were looking for? Perform a search
What's your project topic?
Comment on Facebook:
Related Project Materials
- 1.
IMPACT OF FORMAL EDUCATION ON COMMUNITY DEVELOPMENT IN OREDO LOCAL GOVERNMENT, EDO STATE
ABSTRACT The broad objective of this study is to examine the impact of formal education on community development in Oredo Local Government, Edo State....More »
Item Type: Project Material | 54 pages | 4,750 engagements |
- 2.
CONSTRUCTION OF CRITICAL TEMPERATURE ALARM SYSTEM
ABSTRACT The term “critical point” is sometimes used to denote specifically the vapour liquid critical point of a material. The vapour liquid ...More »
Item Type: Project Material | 46 pages | 11,312 engagements |
- 3.
THE CONSTRUCTION OF LABORATORY EQUIPMENT FOR THE DETERMINATION / INVESTIGATION OF ELECTRICAL INSULAT...
ABSTRACT Insulation deterioration occurs on power system when insulators are subjected to abnormal stresses. Since insulators cannot resist indefinite...More »
Item Type: Project Material | 31 pages | 7,526 engagements |
- 4.
CONSTRUCTION OF 2000W AUTOMATIC VOLTAGE REGULATOR
ABSTRACT This project is all about Automatic Voltage Regulator (AVR), and is a circuit that monitors the input voltage at any point and display the re...More »
Item Type: Project Material | 50 pages | 10,998 engagements |
- 5.
DESIGN AND CONSTRUCTION OF AN ELECTRICAL ROBOTIC TRAIN;THE CONTROL SYSTEM DRIVE(COMPATIBILITY MODE)
1.0 Introduction A robot is a computer controlled machine that can be programmed to move, manipulate objects and accomplish work w...More »
Item Type: Project Material | 34 pages | 8,043 engagements |
- 6.
THE ELECTRICAL DESIGN AND INSTALLATION REQUIREMENT FOR A MEGA FILLING STATION
ABSTRACT A mega filling station can be described from its name –MEGA; which means larger in size. This implies that mega filling station is a lar...More »
Item Type: Project Material | 55 pages | 12,809 engagements |