iProject

THE RATE OF ADSORPTION OF PALM OIL WITH BITUMINOUS COAL

📄 Project Material📋 65 pages📚 Chapters 1–5💾 MS-Word & PDF

Chapters 1–5  |  ₦5,000

Get Complete Project Material Now

 

ABSTRACT

This project was carried out using bituminous coal (non activated) and the degree of refining of palm oil at different temperature and time using spectrophotometer. This was carried out to check the effectiveness of bituminous coal sample (bleaching earth) as a bleaching agent for palm oil.

The coal (bituminous coal) was collected in lump forms, it was air-dried to remove any moisture content, size reduced to refining process.

In the refining process, 1000g of palm oil was weighed with weighing balance. It was then degummed with citric acid solution and neutralized with sodium hydroxide (NaoH) solution. During the process of degumming and neutralization, the residues were removed from the palm oil by allowing it to settle down in a separating funnel and opening the tap to allow the residue to run off. 100g of palm oil was measured with measuring cylinder into a conical flask, 10g of coal (bituminous coal) sample was weighed with meter. P163 weigh balance using pert dish. The coal contained in the Petri dish was added into the conical flask with the palm oil and stirred properly for about 10 minutes. Then it was transferred to water bath for the required temperature and time interval.

Later the coal sample was removed and filtered out with the aid of filter paper to obtain a filtrates. The experiment was performed for five temperature ie 1000c, 1500c,2000c, 2500c and 3000c and with time interval of 20 mins, 40mins, 60 mins, 80mins and 100mins. The colour change after bleaching was measured using spectrophotometer at 520 wavelength. It was noticed that as the temperature increases with time. The percentage colour reduction of the palm oil increases it the higher the palm oil becomes. It was noticed that for bituminous coal, the smaller the particle size of the coal, the higher the percentage colour reduction and percentage oil retention.
TABLE OF CONTENT

CHAPTER ONE

1.1                                      INTRODUCTION                                                    

1.2                                      OBJECTIVE/SCOPE OF THE PROJECT   

CHAPTER TWO

LITERATURE REVIEW                                                     

2.0              ORIGIN OF PALM OIL                                                      

2.1       PROCESSING OF PALM OIL

2.2              PROPERTIES OF PALM OIL                                             

2.3              PHYSICAL PROPERTIES OF PALM OIL                       

2.3.1                    CHEMICAL PROPERTIES OF PALM OIL    

2.4              CHEMICAL COMPOSITION AND                                   

2.4.1                COMPONENTS OF PALM OIL                                         

2.5              USES OF PALM OIL                                                           

2.6              HISTORY OF COAL                                                           

2.7              COAL FORMATION                                                           

2.8              PRODUCTION OF COAL                                      

2.81          MINING                                                                                            

2.82          PREPARATION OF COAL                                    

2.9              PROPERTIES OF COAL                                         

2.91          RANK AND CLASSIFICATION OF COAL        

2.92          COAL UTILIZATION                                                         

2.93          REFINING OF CRUDE PALM OIL                                  

2.94          ADSORPTION                                                                     

CHAPTER THREE

3.0              EXPERIMENT  PROCEDURE                                           

3.1                                      THE RATE OF ADSORPTION OF PALM OIL WITH BITUMINOUS COAL                                                                       

3.2                                      DETERMINATION OF THE COLOUR CHANGE

3.3                                      THE EFFECT OF STIRRING                                              

CHAPTER FOUR

EXPERIMENTAL RESULT                                                            

CHAPTER FIVE

DISCUSSION                                                                                   

CONCLUSION/RECOMMENDATION                            

REFERENCE                                                                        

APPENDIX                                                     

This Project is for You If:

Yes, This Is My Situation — Send Me the Complete Material

Here's everything you get with the complete project package:

✔Chapters 1–5 (Word & PDF)
✔Abstract & Table of Contents
✔References, Citation & Bibliography
✔Fully Editable Microsoft Word Format
✔Original, Plagiarism-Free Content
✔Delivery Within 24 Hours
Complete package —₦10,000₦5,000
Price may return to ₦10,000 at any time.

See Our Conversations With Students on WhatsApp

Students sharing their experience after using our service

Urgent delivery confirmed
Urgent delivery confirmed
Payment received and project delivered
Payment received and project delivered
Quality work and a repeat order
Quality work and a repeat order
Returning customer appreciation
Returning customer appreciation
Customer appreciation
Customer appreciation
I’ve Seen Enough — Get Me This Project Material

What Other Students Are Saying

“The process was actually fine and I got my project quickly. The only thing I didn't really like was that I would have preferred they sent it via WhatsApp instead of email, because email took a bit of checking on my side. But once I got it, everything was already complete and I just edited small parts before submitting.”
Zina
Kenpoly
“My supervisor rejected my Chapter 1 and 2 and I was honestly lost. I got a material here and it already had everything arranged properly. I just adjusted it to my topic and resubmitted. The difference was clear immediately.”
Favour
Nekede
“My supervisor almost finished me 😭 He rejected everything and said I didn't understand basics. I downloaded something here, used it to restructure my work, and resubmitted. That was how I escaped serious stress.”
Nnamdi
Absu

Can't find what you're looking for?

Search thousands of project topics across every department.

Related Project Materials

See More Chemical Engineering Final Year Research Project Topics & Materials »

Frequently Asked Questions

Is this project original and plagiarism-free?
Yes. All project materials on iProject are original, well-researched, and crafted to be plagiarism-free. They are intended as academic guides and reference materials.
What format will I receive the material in?
You will receive the complete project in both Microsoft Word (.docx) and PDF formats, making it easy to edit and submit.
How soon will I get it after payment?
Once payment is confirmed, the material is delivered within 24 hours to the email address supplied at checkout.
Can I edit the content to fit my own case study?
Absolutely. The Word format is fully editable, allowing you to modify the content, swap out case studies, and adapt the material to your specific research context.
All My Questions Are Answered — Download the Complete Project
Message us