ABSTRACT
This study is a comparative analysis of the use of coal, fuel oil and natural gas for cement production noting their physical and chemical properties, cost and availability, impact on the environment and human health. Out of the seven cement manufacturing industries in Nigeria, three industries use these fuels were selected for the study. The industries are NigerCem βEbonyi state, Dangote cement βBenue state and UniCem -Cross river state. Questionnaires were used to gather information on the three fuels. The likert 3- scale model was adopted, using 2.0 as the cut off mark. Based on the analysis of the study, it was observed out that amongst these three (3) fuels, fuel oil is presently expensive though available, while coal and natural gas are cheap but coal is not available due to the closure of Nigeriaβs coal mine. In terms of environment and health, coal and fuel oil emit much harmful gases to the environment and cause more health problems to cement worker but natural gas emits less of these harmful gases to the environment and cause less health problems to workers. The study therefore shows that natural gas is the best fuel because it is cheap, readily available and creates fewer problems to the environment.
7
TABLE OF CONTENTS
Title page
Certification ---------------------------------------------------------------------------- ii
Approval ------------------------------------------------------------------------------- iii
Dedication ----------------------------------------------------------------------------- iv
Acknowledgement -------------------------------------------------------------------- v
Abstract -------------------------------------------------------------------------------- vi
Table of contents ---------------------------------------------------------------------- vii
CHAPTER ONE
INTRODUCTION
1.1 Background of study ------------------------------------------------------------ 1
1.2 Statement of problem ------------------------------------------------------------ 2
1.3 Aims and objectives ------------------------------------------------------------- 2
1.4 Significance of study ------------------------------------------------------------ 3
1.5 Scope of study -------------------------------------------------------------------- 3
CHAPTER TWO
LITERATURE REVIEW
2.1 Energy source --------------------------------------------------------------------- 5
2.1.0 Coal ------------------------------------------------------------------------------ 5
2.1.1 Fuel oil -------------------------------------------------------------------------- 15
8
2.1.2 Natural gas --------------------------------------------------------------------- 15
2.2 Cement ---------------------------------------------------------------------------- 17
2.2.0 Cement manufacturing processes -------------------------------------------- 18
2.2.1 Major characteristics of cement industry ---------------------------------- 22
2.2.2 Energy challenge in the industry -------------------------------------------- 23
2.2.3 Demand for cement ------------------------------------------------------------ 25
2.2.4 Emission from cement industry ---------------------------------------------- 26
2.3 Conceptual framework ----------------------------------------------------------- 30
CHAPTER THREE
RESEARCH METHODOLOGY
3.1 Research methods ----------------------------------------------------------------- 31
3.2 Sample procedure/sample size determination --------------------------- ----- 31
3.3 Data collection -------------------------------------------------------------- ------ 33
3.4 Operational measures of the variable ------------------------------------------- 33
3.5 Research analysis ----------------------------------------------------------------- 34
CHAPTER FOUR
PRESENTATION AND ANALYSIS OF DATA
4.1 Data presentation ----------------------------------------------------------------- 35
CHAPTER FIVE
SUMMARY, CONCLUSION AND RECOMMENDATION
9
5.1 Summary ------------------------------------------------------------------ 50
5.2 Conclusion ---------------------------------------------------------------- 51
5.3 Recommendation -------------------------------------------------------- 51
REFERENCE --------------------------------------------------------------- 53
APPENDIX ------------------------------------------------------------------ 56
10
CHAPTER ONE
INTRODUCTION
1.1 BACKGROUND OF STUDY
Energy is commonly defined as the ability to do work or to produce heat.
Normally heat could be derived by burning a fuel (i.e. a substance that contains internal energy which upon burning generates heat). (IEA, 2004).
The energy system today is highly dependent on fossil fuel with coal, fuel oil and natural gas accounting for about 80% of world primary energy demand. (Kul, 2001).
Fuels are the major source of energy for industries and cement industry is not an exception. However, the energy source to be adopted will have to meet the varying needs of different countries and at the same time enhance the security of each against the energy crisis that have taken place in the past. The selection/ choice of fuel type depend on various factors such as environmental pollution, ease in processing, storage and handling, availability and cost of the fuel.
Coal, fuel oil and natural gas are the most commonly used energy carrier in cement industries. The energy use for cement production is distributed as follows:-
ο· 92.7% for pyro-processing
ο· 5.4% for finishing grinding and
ο· 1.9% for raw grinding (Choate, 2003).
11
The choice of fuel use entails the level at which green house gases (GHG) are emitted, the cost of cement and the quality of the cement produced.
This research work will help in selecting the best fuel and techniques to be use in order to attain a high quality product at a lower cost with lesser green house gas emission to the environment.
1.2 STATEMENT OF PROBLEM
The choice of fuel is attained by comparative analysis of coal, fuel oil and natural gas in cement production. In comparing these fuels, the following problem arises:-
ο· Knowledge of the physio- chemical properties of coal, fuel oil and natural gas.
ο· Knowledge of the green houses gases (GHG) emitted by each of these fuel, their level of emission and their effects on the environment and humans health (esp. cement workers).
ο· Knowledge of the cost and availability of coal, fuel oil and natural gas.
1.3 AIMS AND OBJECTIVES OF STUDY
The aims of this research work is to;
ο· Study the physical and chemical properties of coal, fuel oil and natural gas.
ο· Gain knowledge on the green house gases (GHG) emitted, their effect on the environment and humans health and the level of emission from each fuel.
ο· Study coal, fuel oil and natural gas in relation to cost and availability.
12
1.4 SIGNIFICANCE OF THE STUDY
With the growth in industrialization today, this study will offer numerous values both to the cement industry and staff, the environment and society at large.
It will choose an economical and less hazardous fuel and techniques for cement production.
Also, it will help in the selection of techniques /fuel that will reduce the emission of green house gases (GHG) from cement industries to the environment. This gases emitted causes acid rain, smog etc. which can cause cancer to human and destroys plant lives.
In terms of infrastructural development, an economical fuel for production will lead to a reduction in the cost of cement, thereby encouraging the development of buildings and Government in development of roads, bridges, and other construction- oriented projects.
This study will also give students of chemical engineering and other related courses an insight of these fuels with their different environmental implications, properties and choice of fuel when combustion of fuel is required.
COMPARATIVE ANALYSIS OF COAL, FUEL OIL AND NATURAL GAS FOR CEMENT PRODUCTION
Chapters 1β5 Β |Β β¦5,000
Download Complete Project NowThis Project is for You If:
- You are writing your final year project for the first time and don't want to make costly mistakes
- This is your exact topic, or very close to what your supervisor gave you
- Your supervisor has rejected one or more chapters and you don't know what to fix
- You are stuck on Chapter 3 or data analysis and nothing is making sense
- Your deadline is close and you are still far behind
- You can't find enough materials anywhere for your topic
Here's everything you get with the complete project package:
See Our Conversations With Students on WhatsApp
Students sharing their experience after using our service





What Other Students Are Saying
Can't find what you're looking for?
Search thousands of project topics across every department.
Related Project Materials
PREPARATION OF SOAP USING DIFFERENT TYPES OF OILS AND EXPLORING ITS PROPERTIES
ABSTRACT Soaps are the sodium salts or potassium salts of stearic acids or any other fatty acids. They are prepared by the saponification process, which is, reacting the oil whichβ¦
π Project Materialπ 50 pagesπ 41 viewsTHE REFURBISHMENT OF TEMPERATURE CONTROL APPARATUS
ABSTRACT A temperature control apparatus an βArmfield model was refurbished. The methodology employed were to detect the pulty parts of the equipment especially in the sump where lβ¦
π Project Materialπ 50 pagesπ 16,075 viewsPRODUCTION OF CRUDE OIL-DRILLING PROCESS
ABSTRACT The tremendous (large) demand of some petroleum fractions in our modern world today has drive some professionals (experts) in oil sectors into exploration and drilling opeβ¦
π Project Materialπ 50 pagesπ 41 viewsPRODUCTION OF LIQUID AND VAPORIZED PERFUME
ABSTRACT This research project was carried out principally for the production of liquid and vapourized perfumes from local raw materials. The local raw material were subjected to vβ¦
π Project Materialπ 50 pagesπ 23,494 viewsPROCESS AND QUALITY FACTORS IN LAUNDRY AND TOILET SOAP PRODUCTION
ABSTRACT This projects is aimed at knowing the process and quality factor in Laundary and Toilet Soap Projection. Various factors affected the quality of the soap produced. These iβ¦
π Project Materialπ 50 pagesπ 17,045 views
See More Chemical Engineering Final Year Research Project Topics & Materials Β»
